topwater frog lure how to use

Well, before I got to obtain on many of these casts a bass would take off on the frog, and I hooked up with many bass that day. In each case the frog was simply sitting motionless for at least one minute before I started the obtain, and I captured bass just while it was sitting still.

My idea is, let the frog sit for a while prior to obtaining. You never know what might shock you! When fishing a frog with paddle feet, stitch the center point of the feet to the frog body with a piece of monofilament. During a fight, this keeps the set of legs from getting tugged out of one side of the frog body or the other, which will mess up the bait.

I have actually changed the length of it to look more like the frog is drifting with its legs outstretched. I have utilized this with all the best near weedbeds and my preferred way simply hopping it off the bank into the water throughout the summer season. A couple of us were on our way back home from a saltwater journey when we decided to make some casts into a little pond we had passed.

This sudden impulse of a modification kept the fish coming, and the natural feel of the bait seemed to keep them from throwing the frog. A technique that I utilize when fishing a hollow-body frog normally a Bronzeye frog, but I am sure that it deals with others is what I call hopping.

The short jerks tend to make the frog plane up on the water, giving it a hopping movement similar to a live frog. Generally the strike will take place on the pause. You will need to experiment to see how long of a time out the fish want, and often it is not essential to stop briefly the lure at all.

To permit the frog to sit deeper in the water and cause more of a commotion when coming through weeds and the water, peel back the rubber frog body and make several wraps around the hook shank with a non-lead soldering wire. Produce various buoyancy qualities by adding or deducting wraps of the soldering wire.

This allows you to use a fragrance that will gradually distribute into the water behind your bass-enticing frog! I also have included a jig rattle to the frog's hook shank to produce a lot more commotion. I use the rubber jig type rattle holder. You can include either a single rattle or two rattles for a lot more noise.

Repeat a couple of times. This will attract the attention of the bass, who at this point is seeing from the cover. Now, cast your frog into the cover. Walk the frog in the cover and soon enough the bass will assault. Hold your rod pointer up high and count to two.

I like tossing frogs and rats. To assist zip them out there, I will shove a couple of little worm weights up into the hollow body. They assist pitch the lure out there farther, and they act as a rattle as I chug it back to the boat. Cast the frog onto the bank and pull it into the water about 6 inches off the bank.

Sometimes a still bait is an easy meal for a bass. Have you ever seen a frog chased after off the bank by a snake? The frog will hit the water and swim in two or 3 frenzied spurts, almost clearing the water. If your routine method of fishing your frog seems to not be drawing interest, attempt casting to the waterline and reeling your frog in 2 or 3 quick spurts with a quick pause between each.

A bass will blast the frog as if to disable it and will hit a second time if you don't reel it away. Often this frenzied frog presentation will draw strikes when others will not. Many times I'll get more bites by merely casting the frog onto the shore if the coastline is open enough.

By dragging the frog in from dry land, this develops a more natural entry into the water. A suggestion for fishing plastic frogs utilizing braided line: If you apply a silicone dry fly spray or paste to the first 5 feet of the line, it will keep the line floating on the surface, guaranteeing much better hook sets and frog performance.

After the cast, give the frog a medium powered jerk and the frog will hop out of the water. Fly tiers have actually utilized this technique on their poppers for ages, yet you never ever hear or see anything about it. Works like a charm, every time. Use 3/16-inch orthodontics elastics one-third of the way up each leg skirt, doubling the flexible to hold the skirt product tightly together, like a collar on a spinnerbait or jig skirt.

This is more effective in open water fishing because the leg skirts are united, producing a less weedless discussion. The benefit of this modification is that it makes the frog walk more successfully and look more natural! When you're fishing a frog or any topwater lure, you have to be extremely patient not only before a strike however after, too.

I can't count how many times enjoyment took over when a huge bass took off on my frog, and I jerked it away from the bass before he might truly take it. Here are a couple of suggestions I have discovered over the years to increase your number of strikes and hookups with a frog.

There are 2 ways to do this. One way is to pull the skirt product out of the rear of the frog. Insert 8 brass rattles made for tube baits into the holes where you pulled the skirt out. Using a piece of 25-pound mono, Super Glue the line to the center of the skirt.

Pull the line and skirt out to length and cut the line. The next way is the simplest. Cut a small hole in the leading rear of the frog. Insert rattles through the cut hole and usage silicone to plug the hole. Cut the skirt off 1 inch long on each side.

I utilize a heat weapon or blow clothes dryer to make the bait concave on top, despite the fact that the bait is hollow. Start 1/4-inch in front of the hook point and go 1 inch forward. Just concave about 1/4-inch deep. The bait will be just as weedless, and your connection ratio will increase.

They include weight to make the bait sit lower in the mat and also sound to attract fish. Throw your frog into the mat, move it a couple of inches and shake it in one place. Then move it a few inches and repeat. You have to offer the fish time to discover the bait in thick mats.

Try to cast it in near hang over the end of a tree branch. Reel it in till it's hanging vertically off the branch. (Sometimes it gets slammed early.) Just bob it up and down with the legs hanging in the water. When the bass grabs it and the line snaps off completion of the branch, there is adequate slack so you will not set the hook too early.

On some frogs, the skirt that comprises the legs runs in one side of the frog and out the other. If you pull on one leg and make it a little longer than the other, the bait will have some walk-the-dog action on its own. The most apparent tip is my favorite: Match the hatch.

We use the smallest frog we can locate, toss it up on the bank or coastline, and "pop" it into the water. Let it sit for no more than 2 seconds, and pop it away from the dirt. This is in open water and right up against standing tules, sunken brush and fallen trees.

Sometimes, I couldn't count the number of big bass that I caught out of these little places. As I walked the bank, I was constantly frightening up frogs, generally leopard frogs. Today, there are lots of types and makers of frogs, however back then, there were really couple of.

Those little babies were great right out of package, but needed more action for the angler to not have to present the effort. While taking a break one evening, I was looking at my frog and wondering what could be done. I began to take apart the frog and I noticed the skirt simply slipped over the hook.

When I put the skirt back on, I realized that I had put it on in reverse. When the rod was jerked to make the frog move, the skirt would straighten, much like the legs of a live frog, and when the frog was resting, the skirt flared out similar to a frog does when it is resting on the water.

Try this little technique for affordable baits to get more action out of them. The technique can be utilized on rats in addition to spinnerbaits that have a "one-way skirt," like the H&H Spinner. This little pointer will absolutely assist you put more bass in the boat. Casting the frog straight onto the bank (on dry ground) is a great way to get bass to bite.

Cast the frog high and let it hit the moss with a loud plop. Just let it sit there. With the rod idea held high, do not move the frog but simply plop it numerous times, moving the moss. Hop it once and hang on. I've been fishing on Lake Texoma for rather some time and my mom of all people purchased some weedless frogs out of an Outdoor Life magazine that at the time were the big buzz for capturing bass.

When we began casting we expected to catch fish near the coastline, but as we slowly obtained and stopped briefly the frog we did not get any hits up until the lure was reasonably near the boat. I was still a beginner it took me numerous missed fish before I remembered fishing on a pond in Rhode Island where my dad told me to count to 10 prior to setting the hook.

For a totally silent but deadly lure discussion, cast your frog onto the coast and pull it into the water. I find this to work more times than not. It does not matter if there is cover or simply open water if you find an area that is regularly under shade, causing the water temps to stay a little lower than the remainder of the pond/lake.

We would cast our frogs out over the moss that extended out over the edge of the pond roughly 20 or so feet. We would cast out as far as we could, then stroll the frog in to the edge of the moss. If we didn't get a bite on the method in, we would let the frog sit at the external edge of the moss and then wiggle the idea of our poles to make the frog shake.

Talk about thrilling! While fishing one day I saw a huge bass come out from under a log at the edge of some lily pads to take a look at the buzzbait I was pitching at the time. Over the next several days, I boiled down and fished that area a minimum of as soon as a day with different lures and methods to attempt to bring this bass to strike.