how to use topwater frog lure

Well, before I got to recover on the majority of these casts a bass would explode on the frog, and I hooked up with lots of bass that day. In each case the frog was just sitting still for at least one minute before I started the recover, and I captured bass only while it was sitting still.

So my idea is, let the frog sit for a while prior to obtaining. You never ever understand what might shock you! When fishing a frog with paddle feet, stitch the center point of the feet to the frog body with a piece of monofilament. During a fight, this keeps the set of legs from getting tugged out of one side of the frog body or the other, which will ruin the bait.

I have altered the length of it to look more like the frog is drifting with its legs outstretched. I have used this with great luck near weedbeds and my preferred method simply hopping it off the bank into the water during the summertime. A number of us were on our way back home from a saltwater journey when we chose to make some casts into a small pond we had actually passed.

This unexpected impulse of an adjustment kept the fish coming, and the natural feel of the bait appeared to keep them from tossing the frog. A technique that I utilize when fishing a hollow-body frog usually a Bronzeye frog, but I make sure that it works with others is what I call hopping.

The short jerks tend to make the frog aircraft up on the water, providing it a hopping motion comparable to a live frog. Generally the strike will happen on the time out. You will need to experiment to see the length of time of a pause the fish want, and sometimes it is not necessary to pause the lure at all.

To allow the frog to sit much deeper in the water and cause more of a turmoil when coming through weeds and the water, peel back the rubber frog body and make numerous twists around the hook shank with a non-lead soldering wire. Develop various buoyancy qualities by adding or subtracting wraps of the soldering wire.

This allows you to apply a scent that will slowly disperse into the water behind your bass-enticing frog! I likewise have added a jig rattle to the frog's hook shank to create even more commotion. I use the rubber jig type rattle holder. You can include either a single rattle or 2 rattles for a lot more noise.

Repeat a couple of times. This will attract the attention of the bass, who at this moment is viewing from the cover. Now, cast your frog into the cover. Stroll the frog in the cover and soon enough the bass will attack. Hold your rod suggestion up high and count to 2.

I like tossing frogs and rats. To assist zip them out there, I will shove a couple of small worm weights up into the hollow body. They assist pitch the lure out there further, and they act as a rattle as I chug it back to the boat. Cast the frog onto the bank and pull it into the water about 6 inches off the bank.

Sometimes a still bait is a simple meal for a bass. Have you ever seen a frog chased off the bank by a snake? The frog will hit the water and swim in two or 3 frantic spurts, almost clearing the water. If your routine approach of fishing your frog appears to not be drawing interest, attempt casting to the waterline and reeling your frog in two or 3 fast spurts with a quick time out between each.

A bass will blast the frog as if to disable it and will strike a second time if you don't reel it away. Sometimes this frenzied frog discussion will draw strikes when others won't. Often times I'll get more bites by merely casting the frog onto the coast if the coastline is open enough.

By dragging the frog in from dry land, this develops a more natural entry into the water. A tip for fishing plastic frogs using braided line: If you use a silicone dry fly spray or paste to the very first 5 feet of the line, it will keep the line drifting on the surface, ensuring much better hook sets and frog efficiency.

After the cast, offer the frog a medium powered jerk and the frog will hop out of the water. Fly tiers have actually utilized this trick on their poppers for ages, yet you never hear or see anything about it. Functions like a beauty, each time. Usage 3/16-inch orthodontics elastics one-third of the method up each leg skirt, doubling the flexible to hold the skirt material securely together, like a collar on a spinnerbait or jig skirt.

This is more effective in open water fishing since the leg skirts are banded together, producing a less weedless discussion. The benefit of this modification is that it makes the frog walk more efficiently and look more lifelike! When you're fishing a frog or any topwater lure, you have to be incredibly patient not just before a strike however after, too.

I can't count how many times enjoyment took over when a big bass took off on my frog, and I jerked it away from the bass before he might actually take it. Here are a couple of tips I have actually found out over the years to increase your variety of strikes and hookups with a frog.

There are two ways to do this. One way is to pull the skirt material out of the rear of the frog. Insert eight brass rattles made for tube baits into the holes where you pulled the skirt out. Using a piece of 25-pound mono, Super Glue the line to the center of the skirt.

Pull the line and skirt out to length and cut the line. The next method is the easiest. Cut a little hole in the leading back of the frog. Insert rattles through the cut hole and usage silicone to plug the hole. Cut the skirt off 1 inch long on each side.

I use a heat gun or blow clothes dryer to make the bait concave on top, although the bait is hollow. Start 1/4-inch in front of the hook point and go 1 inch forward. Just concave about 1/4-inch deep. The bait will be simply as weedless, and your hookup ratio will increase.

They include weight to make the bait sit lower in the mat and likewise sound to bring in fish. Toss your frog into the mat, move it a couple of inches and shake it in one place. Move it a couple of inches and repeat. You need to offer the fish time to discover the bait in thick mats.

Try to cast it in close to hang over the end of a tree branch. Reel it in till it's hanging vertically off the branch. (Often it gets slammed early.) Just bob it up and down with the legs hanging in the water. When the bass grabs it and the line snaps off completion of the branch, there suffices slack so you will not set the hook too early.

On some frogs, the skirt that makes up the legs runs in one side of the frog and out the other. If you pull on one leg and make it a little longer than the other, the bait will have some walk-the-dog action on its own. The most apparent pointer is my favorite: Match the hatch.

We utilize the smallest frog we can locate, toss it up on the bank or coastline, and "pop" it into the water. Let it sit for no more than two seconds, and pop it far from the dirt. This is in open water and right up against standing tules, sunken brush and fallen trees.

Sometimes, I could not count the variety of big bass that I captured out of these little locations. As I walked the bank, I was always frightening up frogs, normally leopard frogs. Today, there are lots of types and makers of frogs, but back then, there were very couple of.

Those little babies were good right out of package, however needed more action for the angler to not need to put forth the effort. While taking a break one night, I was taking a look at my frog and wondering what could be done. I began to take apart the frog and I saw the skirt just slipped over the hook.

When I put the skirt back on, I realized that I had actually put it on backwards. When the rod was jerked to make the frog relocation, the skirt would correct the alignment of out, similar to the legs of a live frog, and when the frog was resting, the skirt flared out similar to a frog does when it is resting on the water.

Try this little trick for economical baits to get more action out of them. The strategy can be utilized on rats along with spinnerbaits that have a "one-way skirt," like the H&H Spinner. This little idea will absolutely assist you put more bass in the boat. Casting the frog straight onto the bank (on dry ground) is a fantastic method to get bass to bite.

Cast the frog high and let it strike the moss with a loud plop. Just let it sit there. With the rod suggestion held high, do not move the frog but simply plop it several times, moving the moss. Hop it as soon as and hang on. I've been fishing on Lake Texoma for quite a long time and my mom of all people purchased some weedless frogs out of an Outdoor Life publication that at the time were the huge buzz for catching bass.

When we started casting we expected to catch fish near to the coastline, but as we gradually recovered and stopped briefly the frog we did not get any hits until the lure was reasonably close to the boat. I was still a novice it took me numerous missed out on fish prior to I remembered fishing on a pond in Rhode Island where my daddy informed me to count to 10 before setting the hook.

For an entirely silent but lethal lure presentation, cast your frog onto the shore and pull it into the water. I discover this to work more times than not. It does not matter if there is cover or just open water if you discover an area that is consistently under shade, triggering the water temps to stay a little lower than the remainder of the pond/lake.

We would cast our frogs out over the moss that extended over the edge of the pond roughly 20 or so feet. We would erupt as far as we could, then walk the frog in to the edge of the moss. If we didn't get a bite en route in, we would let the frog sit at the outer edge of the moss and after that wiggle the suggestion of our poles to make the frog shake.

Speak about thrilling! While fishing one day I saw a substantial bass come out from under a log at the edge of some lily pads to take a look at the buzzbait I was pitching at the time. Over the next several days, I boiled down and fished that area a minimum of when a day with various lures and strategies to try to bring this bass to strike.